2 -1 Product introduction

Frontier power dimmer through input 0/1-10V signal, can be incandescent lamp, 220V halogen lamp, and equipped with adjustable optoelectronic transformer low-voltage halogen lamp dimming, power dimmer single loop output power can reach 2KW.

Model: DK2000-CDV0410L

Power supply: 220V 50HZ

Control signal input: 0/1-10V

Output power: 2KW * 4 channels

2 -2 Product characteristics

• Dimming output is stable, rise time ≥200us

• Multiple temperature protection, safe and reliable

• Rotary shaft wiring cover design, easy wiring

• When the temperature reaches 75±5°C, the output brightness is reduced by half

• Mount type 4-point installation, convenient construction

• When the temperature reaches 85±5°C, turn off the output of the dimmer

• There are feeding holes on the upper, lower and back to adapt to various feeding methods

• Single power supply, independent circuit breaker protection

• Equipped with manual automatic switch, manual switch and dimming

• With short circuit protection, overload protection function

2 -3 Technical parameter

Model DK2000-CDV0410L Dimming rise time 220us in 220V

The power supply voltage is 220V, 50HZ and the external size is 235*280*130 mm

Signal input 0/1-10V Weight 4.2KG

The minimum load is 60W

Output load AC 0-220V front phase dimming housing material, color iron, black

Power output 2KW*4 Protection IP 20, EN 60 529

Output current 10A*4 Implement standard CE

Terminal wire diameter: 2.5-4.0 mm2 Operating temperature range 0 -- +45°C

Type of load

2 -4 Mounting size (mm)

2 -5 Wiring terminal

DK2000-CDV0410L Controller hardware description
project	name	function	remarks
1	Power indicator light	The indicator lights up during normal operation
2	Hand switch	Manually start loop output and close
3	Ground terminal	ground
4	0/1-10V control signal	Input 0/1-10V signal
Five to eight	1-4 group dimming output	Four 220V dimming output circuits
9	N	Zero line input
10	L	Firewire input

2-6 Wiring diagram

2 -7 Installation and debugging

• Wiring specification

• Power phase cable: red 2.5-4mm2 copper conductor

  Neutral wire: light blue 2.5-4mm2 copper conductor

  Ground cable: yellow and green 2.5mm2 copper conductor

• Load cable: Copper conductor with more than 4mm2

• 0/1-10V: 1.0 to 1.5mm2 shielded twisted pair cable

• Open the product package, take out the paper pattern in the package, drill holes in the bearing wall, install expansion screws, and then fix the power dimmer on the wall.

• Connect each input terminal, output terminal, 0/1-10V terminal according to the wiring diagram.

• The input terminal uses single-phase power supply, and each individual loop is connected to the circuit breaker output terminal.

• In use, in case of emergency, you can manually switch on and off the light or dimmer by pressing the four buttons on the panel for a long time. Long press to enter the manual state, cycle dimming, release the button, the light will stop at the current value. In manual state, 0/1-10V signal is not received.

• To exit the manual state and enter the automatic state of receiving 0/1-10V signals, press or power off the device and then power on.

• Turning off the air switch can completely cut off the load power supply.

•