2 -1Product introduction

Frontier power dimmer through input 0/1-10V signal, can be incandescent lamp, 220V halogen lamp, and equipped with adjustable optoelectronic transformer low-voltage halogen lamp dimming, power dimmer single loop output power can reach 4KW.

Model number :DK2000-CDV0320L

Power supply :220V50HZ

Control signal input :0/1-10V

Output power: 4KW *3 channels

2-2 Product characteristics

• 0/1-10V low voltage control, safer

• Multiple temperature protection, safe and reliable

• Dimming output is stable, rise time ≥220us

• Hanging type installation, convenient construction

• When the temperature reaches 75±5°C, the output brightness is reduced by half

• When the temperature reaches 85±5°C, turn off the output of the dimmer

• There are feeding holes on the upper, lower and back to adapt to various feeding methods

• Equipped with manual automatic switch, manual switch and dimming

• Three-phase or single power supply can be used

  
  

2 -3Technical parameter

Model DK2000-CDV0320L Dimming rise time 220us in 220V

The power supply voltage is 220V,50HZ and the external size is 340*280*130 mm

Signal input 0/1-10V Weight 8.8KG

The minimum load is 60W

Output load incandescent lamp housing material, color iron, black

Power output 4KW*3 Protection IP 20, EN 60 529

Output current 20A*3 Implement standard CE UL

Terminal wire diameter: 2.5-4.0 mm2 Operating temperature range 0 -- +45°C

Type of load

2-4 Mounting Dimensions (mm)

2-5Wiring terminal

DK2000-CDV0320L Controller hardware description
project	name	function	remarks
1	Power indicator light	The indicator lights up during normal operation
2	Hand switch	Manually start loop output and close
3	0/1-10V control signal	Input 0/1-10V signal
4	Ground terminal	ground
5	1-3 sets of dimming output	Three 220V dimming output circuits
6	Zero line N	Zero line input
7	Firewire L1	Three-phase live wire input
8	Firewire L2
9	Firewire L3

2 -6Wiring diagram

2 -7Installation and debugging

• Wiring specification

• Power phase cable: red 2.5-4mm2 copper conductor

  Neutral wire: light blue 2.5-4mm2 copper conductor

  Ground cable: yellow and green 2.5mm2 copper conductor

• Load connection: 4mm2 copper conductor

• 0/1-10V: 1.0 to 1.5mm2 shielded twisted pair cable

• Open the product package, take out the paper pattern in the package, drill holes in the bearing wall, install expansion screws, and then fix the power dimmer on the wall.

• Connect each input terminal, output terminal, 0/1-10V terminal according to the wiring diagram.

• When the three-phase power balance is satisfied, the input power supply can also be single-phase, and the input line of a single power supply is connected to the three input terminals at the same time (input terminals in parallel).

• Turn the light on or off by pressing three buttons on the panel. When 0/1-10V sends the corresponding signal, the corresponding terminal 5 will output a corresponding voltage

Please consult our relevant technical staff for details!